Panel van (type 7HK..)
•
Retrofitting of seats and seatbelt anchor points is not possible
•
Kombi/Shuttle (type 7HC) On vehicles with panelled sidewalls at the rear, retrofitting of seats and seatbelt anchor
points for the 2nd and 3rd seat row is not permitted. In the first seat row, there is an option of installing a 2-seater
bench seat plus a single seat. The seat and seatbelt mountings are always installed as standard for the 2- eater
bench seat in the 1st seat row.
Retrofitting of single seat in 1st seat row
•
♦
Removal of relevant components in floor
Riveting in of four reinforcement brackets 2x 7H0.803.547 / 2x7H0.803.548 (see diagram 1.2)
♦
Drilling of seat mounting holes through holes already made in reinforcements, and subsequent
♦
measures to protect against corrosion
Retrofitting of 3-seater bench seat in 2nd or 3rd seat row
•
♦
Removal of relevant components in floor
Drilling of seat mounting holes (see diagram 1) through holes already made in reinforcements, and
♦
subsequent measures to protect against corrosion
1