7. Connection Procedure
This section describes the procedure for connecting the Controller to Inverter via DeviceNet
using the "procedure for using the configuration files".
This document explains the procedures for setting up the Controller and Inverter from the
factory default setting. For the initialization, refer to Section 8 Initialization Method.
7.1. Overview of Setting up Remote I/O Communications
The following figure shows the relationship of processes to perform DeviceNet remote I/O
communications using the "procedure for using the configuration files".
Toolbox
Importing
project file
Sysmac Studio
Transferring
project data
Precautions for Correct Use
Prepare the latest "Sysmac Studio project file" and "CX-Integrator project file" from OMRON
in advance.
(To obtain the file, contact your OMRON representative.)
Sysmac Studio project file
Personal computer
Controller
7.Connection Procedure
CX-Integrator project file
CX-Integrator
Transferring
scan list
Opening
project file
Destination
device
11