Fire Sense 60950 User Manual page 10

8. While supporting heater, tilt the Head and Upper Post Assembly (B) and
screw in the 3 M8x66 Stud Bolts (BB) into the holes on top of the Head
Assembly. Slide the assembled Reflector over the 3 bolts that now extend from
the Head Assembly. Use the 3 M8 Wing Nuts (DD) and 3 M8 Washers (FF) to
secure the assembled Reflector to the Head Assembly of the heater. Once you
have tightened the Wing Nuts, return the heater to an upright position.
Hardware Used: 3 x BB, Stud Bolt with Nut
3 x DD, Wing Nut M8
3 x FF, Washer M8
Connect the hose and regulator to the LP cylinder. The LP cylinder is
9.
sold separately. Use a standard 20 lb. propane cylinder only. Screw
Regulator (D) onto Gas Hose (C). Do not cross thread. Hand tighten securely.
Attach Regulator (D) to valve on LP cylinder and hand tighten securely.
Place LP tank onto base of heater and close Tank Housing Door (I).
NOTE: Use this heater only with a propane
vapor withdrawal supply system. See chapter 5 of
the standard for storage and handling of liquefied
petroleum gas, ANSI/NFPA 58. Your local library or
fire department should have this book.
ASSEMBLY
10
8
10