Page 2
away from flammable liquids and materials. stable and is placed on a level surface. Follow the above instructions and keep this unit at least 3 feet clear from any objects Always be careful when handling this unit, especially around the head of the unit.
Page 3
Head Post Center Post Bottom Post Bottom Post - supports the heater.Electrical cord runs inside this pole. Head Post Connect head unit and base...
Page 4
Keep flammable materials, such as furniture, pillows, bedding, papers cloths, and curtains at least 3 feet from the heater. heater is used near, children or disabled persons. is used near, children or disabled persons. cord cord Always unplug heater when not in use. is 0-50 feet, but if a longer cord is reguired use a 12 gauge longer then 100 feet.
Page 5
affix tilt switch to bracket (diagram, reference 1). Attach bracket with tilt switch to heating unit (diagram ref.2). to the head post. Keep pulling the cord through the bottom of the to the head post. Keep pulling the cord through the bottom of the head post,(diagram ref.4).
Page 6
Take the head post and place the cord down the center of it and into the top of the center post and through the bottom of the center post and into the bottom post. Slide the cord all the way down to the bottom of the bottom post and pull it out the hole on the side of the bottom post.
Page 7
head post. Keep pulling the cord Use four screws to concent one post to another. circumgyrate the bottom post until the screw into the hole of the base.
Page 9
Turn power off,make sure heating head is not hot. Then put back grill and both panels,screwing on both side covers.
Page 10
Fire Sense and Well Traveled Living are registered trademarks of Well Traveled Imports, lnc . All assembly instruction presentations are the property of Well Traveled Imports, lnc. and are protected by U.S. copyrights and trademarks. All rights reserved.