Finishing - Napoleon BGNV42N Installation And Operation Instructions Manual

8
L42 LOUVRE INSTALLATION
FIGURE 17
A
B
SLOT
TAB
A
B
HINGE
SLOT
CLIP
LOGO PLACEMENT
Remove the backing
of the logo supplied
and place on the
glass viewing door,
as indicated.
W415-0377 / E / 11.26.07

FINISHING

UPPER LOUVRES
Insert the louvre tabs into the slots
located at the top left and right cor-
ners of the unit.
LOWER LOUVRES
Insert the hinge clips into the slots
located at the bottom left and right
corners of the unit.
To remove the louvres, pull the back
tabs of the clips forward, while push-
ing the louvre assembly back. Lift
the clip.
½"
LOGO
½"
FIGURE 18
LOG PLACEMENT
PHAZER TM logs and glowing embers, exclusive to Napoleon® Fire-
places, provide a unique and realistic glowing effect that is different
in every installation. Take the time to carefully position the glowing
embers for a maximum glowing effect. Log colours may vary. During
the initial use of the fi replace, the colours will become more uniform as
colour pigments burn in during the heat activated curing process.
FIGURES 19a-e
1. Place the cutout in the bottom of log W135-0297 behind the pilot
assembly. Rest the log against the back wall of the fi rebox.
2. Move the two small logs (W135-0298 & W135-0299) into position,
lining up the studs located on the burner with the holes on the bottom
of the logs.
GLOWING EMBERS
3. Tear the glowing embers into pieces and place along the front
row of ports covering all of the burner area in front of the small
logs (W135-0298 & W135-0299). Care should be taken to shred the
embers into thin, small irregular pieces as only the exposed edges
of the fi bre hairs will glow. The ember material will only glow when
exposed to direct fl ame; however, care should be taken to not block
the burner ports. Blocked burner ports can cause an incorrect fl ame
pattern, carbon deposits and delayed ignition. PHAZERtm logs glow
when exposed to direct fl ame.
4. Place the bottom of the left crossover log (W135-0300) onto the
stud on the left side of the log support. The top of the log should rest
in the pocket on the back log.