Optional Blower Installation - Napoleon BGNV42N Installation And Operation Instructions Manual

5. Place the bottom of the right crossover log (W135-0302) onto
the stud on the right side of the log support. The top of the log
should rest in the pocket on the left crossover log (W135-0300).

OPTIONAL BLOWER INSTALLATION

INSTALLATION TO BE DONE
BY A QUALIFIED INSTALLER
and must be electrically con-
nected and grounded in ac-
cordance with local codes. In
the absence of local codes,
use the current CSA C22.1
in
CANADIAN ELECTRICAL CODE
Canada or the ANSI/NFPA 70
in the
NATIONAL ELECTRICAL CODE
United States.
The three slots allow
FIGURE 21
ease of adjustment
of the blower. For a
quiet running blower,
do not allow the as-
sembly to sit on the
fi rebox base.
Slide the vibration re-
ducing pad (A) into the clip and onto the threaded stud (B) at the
other end, piercing a hole into the pad. The blower must be able to
be positioned entirely onto the pad.
Tilt the blower onto its side. Slide it past the controls and into the
clip (C). Secure to the threaded stud using the lock washer and wing
nut provided. Ensure that the blower does not touch the fi replace
base or the fi rebox.
FIGURE 22
B
A
FIGURE 20
FIGURE 23
C
CHARCOAL EMBERS
Randonly place the charcoal embers along the front and sides of
the log support tray in a realistic manner. Fine dust found in the
bottom of the bag should not be used.
VERMICULITE
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to be
placed on the burner.
CHARCOAL LUMPS
Place the lumps between the logs in a realistic manner taking care
not to block any of the burner ports.
Attach the connectors from the black and white wires to the thermodisc
and secure the ther-
modisc bracket to the
securing stud at the
bottom left of the unit
using a lock washer
and wing nut. En-
sure that the ther-
modisc touches
the fi rebox wall.
FIGURE 24
Attach the connectors from the black and red
wires to the blower.
Attach and secure the variable speed switch
using the nut provided. Plug the harness cord
into the receptacle.
The wire harness provided in this kit is a
universal harness. When installed, ensure
that any excess wire is contained, pre-
venting it from making contact with moving or hot objects.
Because the blower is thermally activated, when turned on, it
will automatically start approximately 15 minutes after lighting
the fireplace and will run for approximately 30-45 minutes after
the fireplace has been turned off. Use of the fan increases the
output of heat.
Drywall dust will penetrate into the blower bearings causing
irreparable damage. Care must be taken to prevent drywall dust
from coming into contact with the blower or its compartment.
Any damage resulting from this condition is not covered by the
warranty policy.
9
FIGURE 25
W415-0377 / E / 11.26.07