Nailing Tab Installation - Napoleon BGNV42N Installation And Operation Instructions Manual

NAILING TAB INSTALLATION

1) Attach the nailing tabs to the corner posts using the 2
sheet metal screws supplied. Secure through
the centre of the top and bottom
slots in the nailing tab and then
through the existing holes in the
corner posts.
If there are no existing holes, follow
these instructions:
Position the nailing tab so that the
front face is offset with the front
edge of the corner post (approx. ½").
Centre the nailing tab vertically on
the corner post.
Figure 12 a.
FIGURE11
Drill through the centre of the top and bottom
slots in the nailing tab. Secure using the two sheet metal
screws supplied. This allows the nailing tab to slide back
and forth for desired framing. Figure 12 b.
2) To determine the fi nal location of the nailing tab you must fi rst
determine the thickness of your fi nishing material (i.e. drywall). This
will determine the dimension from the front edge of the corner post
to the nailing tab. Once the nailing tab is in the desired location,
drill through the centre hole of the nailing tab. Secure with a sheet
metal screw*. Figure 12 c.
* Additional set screws may be installed.
CORNER
POST
NAILING
TAB
TOP
SLOT
A
B
FINISHING
MATERIAL
CENTRE
HOLE
C
Combustible materials may be installed fl ush with the front of the
fi replace but must not cover any of the black face-areas of the fi re-
place. Non-combustible material (brick, stone or ceramic tile) may
protrude in these areas.
Combustible mantel clearance can vary according to the mantel
NAILING
depth. Use the graph to help evaluate the clearance needed. Fig-
TAB
ures 13a-c.
FIGURE 13b
FIGURE 13c
FIGURES 12a-c
The fi replace requires a minimum enclosure height of 72". For tem-
perature requirements, the enclosure space around and above the
fi replace must be left unobstructed.
MINIMUM MANTEL AND
ENCLOSURE CLEARANCES
FIGURE 13a
7
W415-0377 / E / 11.26.07