Britax 7300/B/2010 Series Instructions For Installation & Use page 23

HOW TO INSTALL
F. Position the restraint in forward-facing
mode and align restraint centrally within the
chosen seating position.
Some vehicle seat fabrics (particularly
velours) may be damaged by a child
restraint used continuously. We recommend
the use of a full Messy Mat™or thick towel
to keep the vehicle seat in good condition.
G. Fully lengthen seatbelt. Insert seatbelt
tongue through the "forward-facing" seatbelt
path (yellow path), ensuring that the seatbelt
is behind the harness straps and that the
lap part of the seatbelt is below the hooks
as shown.
If not fitted with lock-off, allow the sash belt
to sit at the top of the seatbelt path, see
figure H . Allow excess sash belt to feed
1
back into the retractor.
H. Engage the seatbelt buckle and tongue,
ensure to remove all slack from the lap part
of the seatbelt 1 by pulling sash belt 2.
I. If fitted with Upper lock-off, grasp the sash
belt 2 between thumb and fingers in each
hand and allow some slack in the belt. Now
slide the slack belt up into the lock-off slot,
up to the top of the slot. If the belt is not
slack it will not enter the lock-off slot.
44
2
Pull sash portion
of seatbelt to
remove slack
1
Lap Seatbelt
H
Without Upper
Lock-off
H
1
Slacken the sash
belt and feed into the
lock-off
Ensure lap part of
seatbelt is below
I
the hooks
J. Pull the sash belt 2 through the lock-off to fully
tighten the seatbelt. The sash belt 2 must not be
tight when feeding it into the lock-off slot. The
child restraint should now be firmly fitted to the
vehicle seat.
Allow the excess sash belt to feed back into
retractor.
K. Fit the attachment clip on the upper anchorage strap to
the car's anchor fitting as shown. Make sure to remove as
many twists as possible from the upper anchorage strap.
Always attach the hook and remove slack
L. Tighten the Adjustable Upper Anchorage Strap by
pulling the adjustment strap to remove slack as
shown below, but do not over-tighten causing the
restraint base to lift off the vehicle seat.
M. Roll up the excess strap tightly so the webbing is
thick enough to be held in the storage band.
NOTE: Seatbelt extenders should not be used if the
seatbelt is not long enough to secure the child restraint.
If they are used then the buckle tongue must not enter
the seatbelt path.
HOW TO INSTALL
Pull the sash belt
through the lock-off
to fully tighten the
seatbelt
2
J
Attachment Clip
Car's Anchor Fitting
Storage
Band
Press
Pull Adjustment
Strap to remove
slack
Roll up excess
strap tightly so the
webbing is thick
enough to be held
in the storage band.
45