How To Install - Britax 7300/B/2010 Series Instructions For Installation & Use

HOW TO SETUP
E. Connect the shoulder strap to metal strap connector at rear of restraint, ensuring that there are no
twists in the shoulder strap. Ensure the strap passes over the bar.
F. Repeat for other shoulder strap. It is better to change one strap at a time so that the other strap will
be a guide for re-assembly.
If using the head pillow adjust the height using the adjusters so the side wings of the head pillow are
just above the shoulders. See page 55 and 56 for adjustment method.
IMPORTANT:
Ensure the shoulder strap is threaded through the slot, then over the top of the bar at the rear of
restraint & connected to the metal strap connector.
IMPORTANT:
Do not use the restraint with harness shoulder straps set at different heights or fed through
mismatching slots. Ensure harness straps are not twisted and that all straps are secure by pulling
each harness strap.
IMPORTANT:
The Padded Insert (if fitted) is designed to snugly fit baby, providing extra support and comfort it
must be used for smaller babies. Discontinue use when baby's shoulder's reach the Lower Shoulder
Height Marker, the Insert is a tight fit or creates discomfort for larger babies.
20
INSTALLING INTO VEHICLE
(REARWARD-FACING)
The restraint is normally packaged in the fully
upright child use mode so if you need to install for
baby use you must first fully recline the restraint as
described on page 15 or 16 to convert the restraint
to baby use mode.
For illustration of the install method, the drawings
show the restraint with a base but the method also
applies with the recline foot version of this child
restraint.
If the Upper Anchorage Strap is folded up for
storage, undo Storage Strap then lengthen. Fully
press the Adjuster Button (1) while pulling the
Upper Anchorage Strap (2) to lengthen.
A. Position the restraint rearward-facing in the
chosen seating position.
B. Lift the flap at the end of the seat sufficiently to
access the stabilising bar, pull out stabilising
bar and then gently push bar forward until a
click is heard. The Stabilising bar is now locked
in place. Refit the cover. See Fig 1.
C. Undo the buckle and place the straps to each
side.

HOW TO INSTALL

Fully press Adjuster Button (1) while pulling
Upper Anchorage Strap (2) to lengthen.
1
2
Storage
Band
Lift trim enough
to access the
stabilising bar
B
Then push bar
Click
forward
Pull out
Stabilising
bar
B
Fig 1.
21