Filling The Kettle; Switching Off - Russell Hobbs 19340 Instructions And Warranty

OPERATING INSTRUCTIONS
BEFORE USING THE KETTLE FOR THE FIRST TIME

Fill the kettle to the Max point, boil, discard the water, then rinse the kettle. Do
this three times, to remove manufacturing dust, and other impurities.
POSITIONING

Place the kettle stand on a stable, level surface. Ensure that the cable is
positioned so that it does not hang over the surface edge where it can be hooked
or tripped over by persons walking past.

Wind excess cable into the convenient storage facility beneath the kettle stand.

FILLING THE KETTLE


Remove the kettle from the stand.

Press the lid lock to open the lid.

Fill with at least 2 cups of water, but not above Max point.

If you overfill the kettle, it may spit boiling water while operating.

Close the lid, and press it down, to secure it in place.

Check that the lid is closed, or the kettle will not switch off when it boils.
SWITCHING ON

Gently position the kettle on the stand.

Plug the stand into the wall socket. ( switch the socket on)

Move the switch to
Please beware of escaping steam from the lid of the kettle when in use.

SWITCHING OFF


When the water has boiled, the kettle will switch off automatically and the light
will go off.

To switch off manually, move the switch to

The kettle can be switched off at any time before the water boils by lifting the
kettle off the stand.
– the light will glow, and the kettle will heat up.
6