Filling The Kettle - Russell Hobbs SECK43 Instructions And Warranty

BEFORE USING THE KETTLE FOR THE FIRST TIME
Carefully remove your kettle from the box. You may wish to retain the packaging for warrenty claiming
purposes. Before first use, fill the kettle with cold water to the MAX water level mark, bring to boil and discard
the boiling water – do this twice. This will ensure that any residues left over from the manufacturing process
are completely removed.
POSITIONING THE KETTLE
● Position the power base on a dry flat surface away from any potential heat source.
● Unwind the length of the mains cable required to reach the mains socket.
● Ensure the mains cable does not hang over the work surface edge.

FILLING THE KETTLE

● Remove the kettle from the power base.
● Open the lid.
● Fill the kettle between the MIN and MAX markings on the water level indicator with cold water.
● Close the lid and place the kettle back on the power base. Make sure the lid is securely closed before
boiling.
● Always remove the kettle from the power base before filling. Do not fill the kettle above the MAX mark
or below the MIN mark on the water gauge.
SWITCHING ON
5