Filling The Kettle - Russell Hobbs RHSWIRLK Instructions And Warranty

FILLING THE KETTLE

Remove the kettle from the power base.
•
Open the lid by pulling the lid upwards.
•
Fill the kettle between the MIN and MAX markings on the water level indicator
•
with cold water.
Close the lid and place the kettle back on the power base. Make sure the lid is
•
securely closed before boiling.
Always remove the kettle from the power base before filling. Do not fill the kettle
•
above the MAX mark or below the MIN mark on the water gauge.
SWITCHING ON
Position the kettle on the power base.
•
Plug the kettle into a mains supply socket.
•
To start boiling the kettle, press the on/off switch down to "1" (on) position.
•
The power indicator light will illuminate and the kettle will start to boil.
•
Never open the lid during boiling.
•
Do not operate this kettle without the filter fitted.
•
Please beware of escaping steam from the lid of the kettle when in use.
BOIL DRY HEATING PROTECTION
If you have forgotten to add water or the water inside is below the minimum
•
accepted level, the metal sheet for dry heating protection of the temperature
controller will disconnect automatically when the kettle is switched on in order to
protect the kettle from being damaged by dry heating.
If the above situation happens, please turn off the power supply, unplug the kettle
•
and wait 10 minutes for it to cool down. Once this is done, the temperature
controller connects and the kettle will operate normally again.
Note: Do not add cold water in the kettle in an attempt to cool it down quicker – this will
decrease the life span of the kettle's heating plate.
6