Troubleshooting - Black & Decker BDCS40BI Instruction Manual

Problem
• Tool will not charge.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACk+DECkER help line at
1-800-544-6986.
MaInTenance
Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part of
the tool into a liquid.
IMPorTanT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment (other than those listed
in this manual) should be performed by
authorized service centers or other qualified
service personnel, always using identical
replacement parts.
acceSSorIeS
Recommended accessories for use with
your tool are available from your local
dealer or authorized service center. If you
need assistance regarding accessories,
please call:
1-800-544-6986.
warnInG:
The use of any accessory
not recommended for use with this tool
could be hazardous.
BaTTery reMoval
Before attempting to disassemble this tool,
turn it on and run it in either direction until
it stops to ensure a complete discharge of
the batteries. Using a phillips screwdriver,
remove the screws from the product housing
and take the two body halves apart. Lift
the batteries out and pull off the terminal
clips. See "Service Information" for battery
replacement and RBRC for battery recycling.

Troubleshooting

Possible cause
• Charger not plugged into
a working outlet.
• Surrounding air temperature
too hot or too cold.
THe rBrc™ Seal
The RBRC™ (Rechargeable
Battery Recycling Corporation)
Seal on the lithium-ion battery
(or battery pack) indicates
that the costs to recycle the
battery (or battery pack) at the end of
its useful life have already been paid by
BLACK+DECKER. In some areas, it is
illegal to place spent lithium-ion batteries in
the trash or municipal solid waste stream
and the RBRC program provides an
environmentally conscious alternative.
RBRC in cooperation with
BLACK+DECKER and other battery
users, has established programs in the
United States and Canada to facilitate the
collection of spent lithium-ion batteries.
Help protect our environment and conserve
natural resources by returning the tool to
an authorized BLACK+DECKER service
center for recycling. You may also contact
your local recycling center for information
on where to drop off the spent battery, or
call 1-800-8-BaTTery.
noTe: Batteries are integrated into the
tool and should not be removed. To
recycle, return the tool to an authorized
BLACK+DECKER service center.
ServIce InforMaTIon
All BLACK+DECKER Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable power tool
service. Whether you need technical advice,
repair, or genuine factory replacement parts,
contact the BLACK+DECKER location nearest
you. To find your local service location, call:
1-800-544-6986 or visit
www.blackanddecker.com
8
Possible Solution
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Move charger and tool
to a surrounding air
temperature of above 40
degree F (4,5°C) or below
105 degree F (40,5°C).