Usb Board - HP ENVY 17 Maintenance And Service Manual

USB board

Description
USB board for use with HP ENVY 17 Notebook PC computer models
USB board for use with HP ENVY 15 Notebook PC computer models
Before removing the USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the base enclosure and top cover (see
Remove the USB board and cables:
1. Disconnect the USB cable from the ZIF connector (1).
2. Remove the Phillips screw securing the USB board (2), and lift the USB board (3) to remove it.
Reverse this procedure to install the USB board and cables.
Battery on page 42).
Optical drive on page 43).
Base enclosure on page
Component replacement procedures
Spare part number
763709-001
763786-001
46).
65