3.
Remove the power connector cover by removing the screw (1) and lifting the cover (2).
NOTE:
removed during the base enclosure and top cover removal process.
NOTE:
procedure is to remove the power connector cover if you did not remove it when removing the
display panel.
4.
Remove the six Phillips screws (1).
5.
Lift the system board (2), and then remove the system board (3) by sliding it up and to the right
at an angle.
6.
Turn the system board over and remove the solid sate drive before replacing the system board.
70
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
The power connector cover has two Phillips screws, however, the screw on the left is
You will remove the power connector after you have removed the system board. This