Power Connector Cable; Remove The System Board - HP ENVY 17 Maintenance And Service Manual

Power connector cable

Description
For use only on computer models equipped with a graphics subsystem with discrete memory
For use only on computer models equipped with a graphics subsystem with UMA memory
Before removing the power connector, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the subwoofer (see
9. Remove the system board (see
Remove the power connector cable:
1. Release the metal clip to disconnect the power connector cable (1) from the system board.
2. Disengage the cable from the clips (2).
3. Release the clips (3), and then remove the power connector cable (4).
Reverse this procedure to install the power connector cable and bracket.
Battery on page 42),
Optical drive on page
WLAN module on page
Subwoofer on page
System board on page
43).
Base enclosure on page
59).
63).
67).
Component replacement procedures
Spare part number
720240-001
720241-001
46).
77