Drive Shaft Corrosion Protection; Ski/Wakeboard Post(If So Equipped); General Inspection And Cleaning - SeaDoo RXP 4-Tec Supercharged Operator's Manual

Drive Shaft Corrosion
Protection
To protect drive shaft against possi-
ble corrosion, it is recommended to
bring the watercraft to an authorized
Sea-Doo dealer for proper lubrication.
Ski/Wakeboard Post
(if so equipped)
Check ski/wakeboard post operation.
Ensure it slides up and down easily.
Check locking mechanism operation.
Check fasteners tightness. If some-
thing is found defective, don't use ski/
wakeboard post and see an authorized
Sea-Doo dealer for repair.
General Inspection and
Cleaning
Inspection
Check engine compartment for any
damage and for leaks of fuel, coolant
or oil. Ensure all hose clamps are
properly secured and no hose is
cracked, kinked or presenting any
other damage.
WARNING
If any gasoline leak and/or odor are
present, do not start the engine.
Have the watercraft serviced by an
authorized Sea-Doo dealer.
Inspect muffler, battery, fuel tank and
oil reservoir fastening devices. Visu-
ally check electrical connections for
corrosion and tightness.
Inspect hull and jet pump water intake
grate for damage. Replace or have
damaged parts repaired.
WARNING
Periodically verify the seat lock pin
and tighten if needed. Make sure
seat securely latches.
Cleaning
The bilge should be cleaned by an
authorized Sea-Doo dealer to remove
any fuel/oil/electrolyte deposits and
mildew.
Occasionally, wash the body with wa-
ter and soap (only use mild detergent).
Remove any marine organisms from
engine and/or hull. Apply non-abrasive
wax such as silicone wax.
CAUTION:
and plastic parts with strong deter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
Stains may be removed from seat and
fiberglass with Knight's Spray-Nine
from Korkay System Ltd or the equiv-
alent.
Respect the environment by ensuring
fuel, oil or cleaning solutions do not
drain into the waterways.
_____________________
www.SeaDooManuals.net
Never clean fiberglass
97