Preseason Preparation - SeaDoo RXP 4-Tec Supercharged Operator's Manual

Clean the bilge with hot water and de-
tergent or with bilge cleaner. Rinse
thoroughly. Lift front end of water-
craft to completely drain bilge.
Anticorrosion Treatment
Wipe off any residual water in the en-
gine compartment.
Spray Bombardier LUBE lubricant or
equivalent over metallic components
in engine compartment.
WARNING
Do not lubricate the safety lanyard
post.
Lubricate the throttle cable with
Bombardier LUBE lubricant or equiva-
lent.
Final Steps
If any repairs are needed to body or
to the hull, contact your authorized
Sea-Doo dealer. For paint touch up
of mechanical parts use Bombardier
spray paint.
Apply a good quality marine wax to the
body.
The seat and the seat extension
should be partially left opened. This
will prevent engine compartment con-
densation and possible corrosion.
If the watercraft is to be stored out-
side, cover it with an opaque tarpaulin
to prevent sun rays and grime from af-
fecting the plastic components, water-
craft finish as well as preventing dust
accumulation.
CAUTION:
The watercraft should
never be left in water for storage.
Never leave the watercraft stored in
direct sunlight. Never store water-
craft in a plastic bag.

Preseason Preparation

Use the following chart.
Since technical skills and special
tools are required, some operations
should be performed by an authorized
Sea-Doo dealer.
Only perform procedures as de-
tailed in this guide. It is recom-
mended that the assistance of
an authorized Sea-Doo dealer be
periodically obtained on other
components/systems not covered
in this guide. Unless otherwise
specified, engine must not be run-
ning and the safety lanyard must
be removed from its post for all
maintenance procedures.
ponents inside engine compart-
ment may be hot. When compo-
nent conditions seem less than
satisfactory, replace with genuine
BOMBARDIER parts or approved
equivalents.
_____________________
www.SeaDooManuals.net
WARNING
Com-
101