Launching/Loading; Storage - SeaDoo RXP 4-Tec Supercharged Operator's Manual

NOTE:
When trailering 2 watercraft, it
may be necessary to remove the inner
wakeboard rack.
All Models
A Sea-Doo cover can protect the wa-
tercraft, particularly before driving on
dirt roads, to prevent dirt entry through
the air intake openings.
Observe trailering safety precautions.

Launching/Loading

CAUTION:
Before launching the
watercraft, ensure the bilge drain
plugs are fully screwed. After load-
ing the watercraft, ensure they are
removed to drain bilge.

Storage

WARNING
Because fuel
flammable, have an authorized
Sea-Doo dealer inspect the fuel
system integrity as specified in the
periodic inspection chart.
It is recommended that the watercraft
be serviced by an authorized Sea-Doo
dealer for storage but the following op-
erations can be performed by you with
a minimum of tools.
CAUTION:
Do not run the engine
during the storage period.
Body Rinsing/Repair
Wash the body with soap and water
solution (only use mild detergent).
Rinse thoroughly with fresh water.
Remove marine organisms from the
hull.
CAUTION:
Never clean fiberglass
and plastic parts with strong deter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
For gelcoat repairs, refer to an autho-
rized Sea-Doo dealer. Replace dam-
aged labels/decals.
and oil are
_____________________
www.SeaDooManuals.net
Fuel System
Sea-Doo fuel stabilizer (or equivalent),
can be added in fuel tank to prevent
fuel deterioration and fuel system
gumming. Follow stabilizer manufac-
turer's instructions for proper use.
CAUTION:
Fuel stabilizer should
be added prior to engine lubrication
to ensure fuel system components
protection against varnish deposits.
WARNING
Always stop the engine before re-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventilated
area. Do not smoke or allow open
flames or sparks in the vicinity.
Fuel tank may be pressurized, turn
cap slowly when opening. Never
use an open flame to check fuel
level. When fueling, keep water-
craft level. Do not overfill or top
off the fuel tank and leave water-
craft in the sun. As temperature
increases, fuel expands and might
overflow. Always wipe off any
fuel spillage from the watercraft.
Periodically verify fuel system. Al-
ways turn the fuel tank valve (if so
equipped) to OFF position when
the watercraft is not in use.
Engine Oil and Filter
Replacement
The oil change and filter shoul d be
performed by an authorized Sea-Doo
dealer.
Exhaust Cooling System
Flushing and Engine Internal
Lubrication
Lubrication
Connect a garden hose to cool the ex-
haust system as expl ained in FLUSH-
ING under POST-OPERATION CARE.
Bring engine to nor mal operating tem-
perature.
99