Table of Contents
Advertisement
Cleaning the fluff
filter
Cleaning the
moisture sensors
30
Bobbling (fluff) occurs as clothes etc. are used. These
bobbles come off during the drying cycle and collect
in the fluff filter.
0.
The filter must be cleaned after each drying cycle. A
clogged filter results in longer drying times and higher
energy consumption.
1. Open the door.
2. Pull out the filter.
3. Remove the fluff (by drawing your hand across the
filter).
4. Replace the filter (it can only be inserted one way
round).
5. Close the door.
Cleaning during a cycle
If the Filter" indicator lamp comes on and a buzzer
sounds while the dryer is on, clean the filter immedia
tely.
1. Allow the dryer to cool slightly and then clean the
filter as described above.
2. Press the Start/Stop button.
i Very dirty or blocked filters should be rinsed under
warm running water.
The filter must be dried thoroughly before being
replaced.
A thin layer of limescale may build up on the moisture
sensors on the inside front wall of the appliance after
long periods in operation.
1. Open the door.
2. Clean the moisture sensors using a scouring spon
ge.
i Do not use steel wool or abrasive cleaning agents.
0.
0.
Hide quick links:
Advertisement
Table of Contents
