Drying; Cleaning The Fluff Filter; Removing The Laundry - Bosch WTC84102BY Instruction Manual

g the dryer for the first time
cycle without any laundry see page 7.
Inspecting
the dryer
nnecting the
mains plug
oading laundry
he programme
1
drying programme ...
2
idual requirements
view, see page 7.
3
(Start/Stop) button
nly operate the dryer
th the fluff filter inserted.

Drying

Control panel
Drum
Fluff filter
Air inlet
Condensate container
Drying
Emptying condensation
Empty the container after every use.
1. Remove the condensate container and hold it
level.
2. Open the locking cap.
3. Pour out the condensation.
Check the valve in the condensate container for dirt:
If there are fluff deposits on the valve
water. Also pour some tap water into the empty condensation
container then pour it out again through the valve.
To do this, press the valve in and allow all the water to drain out.
4. Regularly remove any deposits in the locking cap hole
using a pointed object.
5. Close the locking cap.
6. Always push the tank fully back in until it locks in place.
If the // / (Container//Cleaning) indicator light comes on
after emptying the container see page 10.

Cleaning the fluff filter

Clean the fluff filter after every use.
1. Open the door and pull out the fluff filter.
2. Remove the fluff (brush your hand over the fluff filter).
If the fluff filter is very dirty or blocked, wash it out with warm water
and dry thoroughly.
3. Replace the fluff filter.
4. Remove fluff from door/door area.
Switching off the dryer
Set the programme selector to Off.
Do not leave laundry in the dryer.

Removing the laundry

Your dryer has an automatic anti-crease function. The drum is moved at set intervals for 30 minutes after
the programme has ended. Laundry remains loose and fluffy (for 90 minutes, if additional
function is selected - depending on model).
End of programme
as soon as
Adding or removing laundry
The drying cycle can be interrupted in order to add or remove laundry.
The programme must then be continued or ended.
The drum and the door may be hot!
1. Open the door. The drying process is interrupted.
2. Load or remove laundry and close the door.
3. If required, select a new programme and additional functions.
4. Press the (Start/Stop) button.
3
rinse the valve under running
/ (AntiCrease/End) indicator light flashes
(Easy-iron)
4