Converting The Installed Load - Bosch Maxx WTL 6500 Instruction Manual And Installation Instructions

Converting the
installed load
The dryer has been designed for 10 or 16 amperes.
If the dryer fuse (factory setting) does not correspond
to the socket fuse (household fuse), have the following
steps carried out by an expert:
1. Connect the dryer to the mains electricity, see
page 40.
2. Turn the programme selector to
3. Simultaneously press and hold the M and J but
tons.
4. Turn the programme selector clockwise to C".
5. Release both buttons.
6. Turn the programme selector 5 positions further
clockwise.
7. Press the M button.
8. To switch the fuse:
Press the J button. Pressing it again allows the
setting to be changed.
i If the 16 ampere setting has been selected, the
J lamp flashes.
If the J" lamp has gone out, the 10 ampere set
ting has been selected.
9. To accept the settings:
Press the M button.
10.Turn the programme selector to
0.
o
.
o
.
47