Monarch 9855 Quick Reference page 9

Hide thumbs Also See for Monarch 9855:

Peel

Bar

Low er

Opening

When removing the backing paper, pull up across the

saw-toothed tear edge. Make sure the backing paper tears at

the edge.

Close the printer's cover.

Press Feed/Cut several times to feed at least three labels/tags to

properly position the supply and the ribbon.

To load and use linerless or string tag supplies, refer to the Operator's

Handbook.

A d j u s t i n g t h e W i d e / N a r r o w K n o b s

You may need to adjust the two wide/narrow knobs according to the width

of your supply. For supply that is more than two inches, adjust the knobs

to the wide setting. For supply that is two inches or less, adjust the

knobs to the narrow setting. For linerless supply, use the narrow setting

(knobs are up). For string tag supplies, use the wide setting (knobs are

down).

You must adjust both of the knobs to the

same position. If you experience ribbon

smudging in cold, dry environments, adjust

the wide/narrow knobs to the wide setting.

For wide supplies, push down and turn the

wide/narrow knobs clockwise with a

screwdriver.

For narrow supplies, turn the wide/narrow

knobs counter-clockwise with a screwdriver

until it pops back up. The adjustment is shown in the wide position.

Tear

Edge

Backing

Paper

9855