Adjustment Of Headlamp And Rear Suspension; Exchange Of Bulbs In Headlight; Spark Plugs (Shoes Without Resistor); Ignition Advance Adjustment/Contactless Ignition - JAWA 350 Workshop Manual

WORKSHOP MANUAL
___________________________________________________________________________

Adjustment of headlamp and rear suspension

Load of motorcycle
No load
1 person
2 persons
2 persons + baggage
1 – headlamp in basic position –1,3%
5.2.

Exchange of bulbs in headlight

Take out the headlamp insert, remove the terminal board and then push and rotate the
plastic socket anti-clockwise to disengage it. By pulling it out, you will also release the socket
of the parking light bulb so that it can be removed from the headlamp reflector insert. To
remove the main twin filament bulb, proceed the same way. When reinstalling it, take care
that it fits correctly in the cut outs of the headlamp insert. Likewise the collar of the plastic
socket must fit in the recess of the headlamp insert collar and the flexible contact must touch
the base of parking light bulb.
5.3.

Spark plugs (shoes without resistor)

Make
BRISK
CHAMPION
5.4. Ignition advance adjustment
Ignition advance is adjusted on value
2,5 mm before T.D.C. of piston. When
mounting a sensor, the marking onsensor
capture is positioned against on stator plate.
5.5. Contactless ignition
The set of contactless ignition contains of
magneto A67-1 (rotor A67R-1, stator A67S-
1), sensor SO1T, regulator R67 and ignition
coil Z67. High voltage cable outlets from
ignition coil are protected by rubber hood.
The reverse binding (reversal of poles) of battery causes damage on regulator R 67. The
alluminium plate of stator is fixed to crankcase with 3 screws M6x20 cheese head and with
one screw M6x20 steeple head (sensor). The sensor is fixed to sheet holder and is fastened
with screw M6x16 top stator plate. When shifting the sensor, the ignition advance can be
adjusted. The distance between sensor and rotor projection is 0,4-0,5 mm. Use jig S-97 for
driving the rotor. Any change of connection, eventually thickness of wires which doesn´t
correspond to the original cables is forbidden.
Position II.
1
1
-
-
type
NR15C, N15C
L78
Rear suspension setting
Position III.
-
-
2
-
2 – headlamp in inclination position
37
Position IV.
-
-
-
2