Chassis; Front/Rear Wheel Remove - JAWA 350 Workshop Manual

___________________________________________________________________________
4.1. Front wheel remove
Loosen and unscrew the nut of wheel shaft and remove the dust protecting ring. Loosen the
clamping bolt of the wheel and shift out the shaft. Be carefull not to loose the brake pads
when removing the front wheel from the fork. After removing the wheel it is recommendable
to enter between the brake pads a filler of -at least- the same thickness as the brake disc and
secure it against falling out. During assembly watch the brake disc, to get easily slipped
between the brake pads after having removed the filler. Shaft has to be clean and greased a
bit. After slipping the shaft into the wheel, screw and tighten the nut.Push down the front fork
several time and then tighten the wheel axle with the clamping bolt on the left slider.
4.2. Rear wheel remove
Unscrew the winged nt of therear brake bowden and wheel spindle nut, remove the
washer and pull the spindle out to right side. Than remove the brake reaction link with
the spacer from left side and disengage the wheel from the rear wheel sprocket assembly. Tilt
the bike to the right and take out the wheel with the brake cover with brake shoes. For
refitting the rear wheel, reverse the procedure of its removal. Check the rear brake (wheel has
not to drag) and correct installation of the brake reaction link in the guide on the swing arm.
IV.
Wire spoked wheels
Motorcycle with sidecar
Alloy wheels

CHASSIS

26
WORKSHOP MANUAL