Enabling The Remote Presence Feature; Obtaining The Ip Address For The Imm - IBM System x3550 M3 Type 4254 Installation And User Manual

Type 4254 and 7944
Hide thumbs Also See for System x3550 M3 Type 4254:
Table of Contents

Advertisement

v Uploading a diskette image to the IMM memory and mapping it to the server as
The blue-screen capture feature captures the video display contents before the IMM
restarts the server when the IMM detects an operating-system hang condition. A
system administrator can use the blue-screen capture to assist in determining the
cause of the hang condition.

Enabling the remote presence feature

Use this information to enable the remote presence feature.
About this task
To enable the remote presence feature, complete the following steps:
Procedure
1. Install the virtual media key into the dedicated slot on the system board (see
2. Turn on the server.

Obtaining the IP address for the IMM

To access the web interface, you need the IP address for IMM. You can obtain the
IMM IP address through the Setup utility. The server comes with a default IP
address for the IMM of 192.168.70.125.
About this task
To locate the IP address, complete the following steps:
Procedure
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed
3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. On the next screen, select Network Configuration.
6. Find the IP address and write it down.
7. Exit from the Setup utility.
124
IBM System x3550 M3 Type 4254 and 7944: Installation and User's Guide
a virtual drive
"System-board optional device connectors" on page 42).
Note: Approximately 20 to 40 seconds after the server is connected to power,
the power-control button becomes active.
Note: Approximately 20 to 40 seconds after the server is connected to power,
the power-control button becomes active.
on the screen for only a few seconds. You must press F1 quickly.) If you have
set both a power-on password and an administrator password, you must type
the administrator password to access the full Setup utility menu.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x3550 m3 type 7944

Table of Contents