IBM System x3550 M3 Type 4254 Installation And User Manual page 116

Alignment
pin slots
Figure 79. Microprocessor alignment
Microprocessor
cover release
tabs
Figure 80. Microprocessor cover removal
102
IBM System x3550 M3 Type 4254 and 7944: Installation and User's Guide
microprocessor comes protected between the tool and the microprocessor
cover.
Microprocessor
Alignment
pins
d. Remove the microprocessor installation tool assembly from the package.
Note: Do not rotate the handle on the tool until you are ready to install the
microprocessor into the microprocessor socket.
e. Remove the cover from the bottom of the microprocessor installation tool.
Press both microprocessor cover release tabs outward (in opposite directions
as shown in the illustration) and remove the microprocessor installation tool
with the microprocessor attached.
Installation tool
Microprocessor
cover
f. Carefully align the microprocessor installation tool over the microprocessor
socket.
Attention: The microprocessor fits only one way on the socket. You must
place a microprocessor straight down on the socket to avoid damaging the
pins on the socket. The pins on the socket are fragile. Any damage to the
pins may require replacing the system board.
Installation tool
Microprocessor