IBM System x3550 M3 Type 4254 Installation And User Manual page 110

Figure 72. Optical drive cage installation
10. Reinstall the bezel screws and the video connector screws.
11. Align the cable connector with the connector on the rear of the optical drive
12. Pull the cable connector latch up and hold it there while you slide the cable
Figure 73. DVD drive cable installation
13. Connect the other end of the DVD cable to the connector on the system board.
96
IBM System x3550 M3 Type 4254 and 7944: Installation and User's Guide
Bezel
9. Insert the tabs on the bottom of the bezel into the holes on the chassis.
cage and press the cable connector into the optical drive cage connector until
it is firmly seated.
connector to the left; then, slide the cable connector latch down to lock the
cable in place.
The following illustration shows the cable routing for the DVD cable: The
DVD cable should go on the top of the operation information panel cable (in
the middle) and the Video/USB cable (on the bottom) when all three cables
are installed in the server.
Optical drive cage