Chevrolet Cruze 2011 Owner's Manual page 235

StabiliTrak is on automatically
whenever the vehicle is started. To
assist with directional control of the
vehicle, the system should always
be left on.
TCS/StabiliTrak Light
When the stability control system
activates, flashes on the
instrument panel. This also occurs
when traction control is activated.
A noise may be heard or vibration
may be felt in the brake pedal. This
is normal. Continue to steer the
vehicle in the intended direction.
If there is a problem detected
with StabiliTrak, SERVICE
STABILITRAK is displayed on the
Driver Information Center (DIC).
See Vehicle Messages (Canada
Base Level) on page 5 27 or
Vehicle Messages (Canada Uplevel
and United States) on page 5 28.
When this message is displayed
and/or comes on and stays on,
the vehicle is safe to drive but the
system is not operational. Driving
should be adjusted accordingly.
If comes on and stays on, reset
the system by:
1. Stopping the vehicle.
2. Turning the engine off and
waiting 15 seconds.
3. Starting the engine.
If still comes on and stays on at a
speed above 20 km/h (13 mi/h), see
your dealer for service.
TCS/StabiliTrak Button
is located on the console.
Driving and Operating
StabiliTrak Off
Light
StabiliTrak can be turned off if
needed by pressing and holding
until and come on the
instrument panel. When StabiliTrak
is turned off, the system will not
assist with directional control of the
vehicle or limit wheel spin. Driving
should be adjusted accordingly.
Press and release
the system back on.
If cruise control is being used when
StabiliTrak activates, cruise control
will automatically disengage. Press
the cruise control button to
reengage when road conditions
allow. See Cruise Control on
page 9 36 for more information.
9-35
TCS Off Light
again to turn