Joovy 40X Series Instruction Manual page 6

Front Wheel Locks
The front wheels can be either in swivel
mode or locked mode.
• To put the front wheels in their locked
mode, first rotate each wheel set so
that the wheels are pointed straight
ahead.
• Pull up on the lever to engage the
small tab on the lever with the slot in
the plastic frame sleeve. The lever can
be either facing forward or rearward
to lock the wheels. See Figure 9.
• To unlock the wheels and put them
into swivel mode, push down on the
lever to disengage the tab from the
slot.
Installing and Operating the Canopy
• To attach the canopy, position the canopy on the stroller with the thick padded
edge toward the front of the stroller.
• Line up the male fittings on the canopy with the female fittings near the center of
the stroller and push downward until the fittings snap into place. See Figure 10.
Pull upward on the canopy sides to be sure both are snapped securely in place.
• To open the canopy, pull forward on the front edge of the canopy while holding
the back edge in place. Once the canopy is fully opened, push down on BOTH
side hinges to lock it in the open position.
• The canopy will ratchet forward or backward to help block the sun. Pull forward
on the front of the canopy frame tube to rotate it forward. Pull backward on the
rear frame tube to rotate it backward. See Figure 11.
• To close the canopy, unlock the side hinges and pull the front edge toward the
rear of the stroller until folded. See Figure 12.
• To remove the canopy, press the lock button on the side of each of the male
fittings while pulling upward on the canopy frame. See Figure 13.
Figure 10
Page 5
Figure 9
Figure 11
Caboose Stand-On Tandem Instruction Manual