Honda Nighthawk CB 750 1991 Service Manual page 129

Front Wheel/Suspension/Steering
NOTE
I
.
Reolace the bearinos and races as a set.
At installation, apply grease to all bearing surfaces.
-
Check the steerina head bearins ~reload (oase 1-1 1) after torouins the stem nut
Repuisite Service
Fork removallinstallation (page 10-6)
Handlebar removal/installation (page 10-2)
Meter removal/installation (page 16-5)
I
Procedure
I
Q'W
I
Remarks
I
Removal Order
Steering stem nut
Thrust washer
Ignition switch connector
Top bridge assembly
HeadlightIStay assembly
(1 7) Lower bearing outer race
(6)
(7)
(8)
(9)
(1 0)
(1 1 )
(1 2)
(1 3)
(14)
(1 5)
(1 6)
Lock nut
Lock washer
Steering head bearing adjustment nut
Dust seal
Steering stem
Upper bearing inner race
Upper bearing
Lower bearing
Lower bearing inner race
Dust seal
Upper bearing outer race
After removing, remove the fork tubes.
(1 8)
(1 9)
(20)
(21 )
Disconnect inside the headlight case (page 1-21)
Handlebar holder nut
Washer
Handlebar holder cushion
Handlebar holder
Support with a piece of wire so it dose not hang from the
cable or wire harness.
Remove, after straightening the lock washer tabs.
Use steering stem socket 07916-3710100
- Replace if removed.
-
Use race remover attachment (07953-MJ1010A) with
driver (07949-3710001) and attachment, 37x40 mm
(07746-0010201) for upper outer race removal.
Use race remover (07946-3710500) for lower outer
race removal.
Steering stem
Dust seal
Steering head bearing adjustment nut
Lock washer
Lock nut
HeadlightIStay assembly
Top bridge assembly
Ignition switch connector
Thrust washer
Steering stem nut
(20)
(2 1
)
(1 9)
(18)
(1 7)
(1 6)
(1 5)
(14)
(1 3)
(1 2)
(1 1
)
After installing handlebar, torque the nuts.
-
Replace as a set, if necessary.
-
Use attachment. 52X55mm (07746-0010400) and
driver (07749-001 0000) for lower outer race installa-
tion.
-
Use attachment, 42X47mm (07746-0010300) and
driver (07749-001 0000) for upper outer race installa-
tion. -
Use steering stem driver (07946-MB00000) for lower
inner race installation.
Installation Order
Handlebar holder cushion
Handlebar holder
Washer
Handlebar holder nut
Lower bearing outer race
Upper bearing outer race
Dust seal
Lower bearing inner race
Lower bearing
Upper bearing
Upper bearing inner race
t
Installation : refer to section 18 of the Common Service
Manual (Retainer-Type Ball Bearings).
Temporarily install fork and torque the nut