Honda Nighthawk CB 750 1991 Service Manual page 119

Front Wheel/Suspension/Steering
NOTE
Clutch switch connector
Clutch lever assembly
-
Using wires. hang the front brake master cylinder at least as high as the position it was oringinally installed at t o prevent
air from getting into the master cylinder. Do not twist the brake hose.
Route the cables and wire harnesses properly (page 1-21).
After installing the handlebar, adjust-
.
the throttle cable
.
the clutch cable
the choke cable
(5)
(6)
(7)
( 8 )
Left handlebar switch housing screw
Left handlebar switch housing
Choke cable end
Handlebar grip
(9)
(10)
Align the holder end with the punch mark on the handlebar
and face the holder "UP" mark upward. Tighten the upper
Procedure
Brake light switch connector
Master cylinder
bolt first, then the lower bolt.
Tighten the front screw first, then the rear screw.
Q'tY
2
4
(1
)
(2)
Apply Honda Bond A or Honda Hand Grip Cement (U.S.A.
only) to the inside surface of the grip.
Remarks
Installation is in the reverse order of removal. Removal Order
Rearview mirror
Wire band
(1 1)
(12)
(1 3)
(14)
(1 5)
(1
6)
(1 7)
Align the holder end with the punch mark on the handlebar
and face the holder "UP" mark upward. Tighten the upper
bolt first, then the lower bolt.
Tighten the front screw first, then the rear screw. Right handlebar switch housing screw
Right handlebar switch housing
Handlebar holder bolt
Handlebar holder
Throttle cable end
Throttle pipe
Handlebar
Tighten the front bolts first, then the rear bolts.
Install the upper holder with its punch mark facing forward.
Place the handlebar onto the lower holder and align the
punch marks on the handlebar with lower surface of the
handlebar holder.