Power-Up Procedure - Summa SummaCut D160SE User Manual

SummaCut
!
This cutter must only be used with a power outlet that is properly grounded
to ground. Use of an ungrounded outlet exposes the operator to risk of
electric shock and will also lead to malfunctioning of the cutter.

1.6.2 POWER-UP PROCEDURE

KEEP FINGERS AND OTHER BODY PARTS AWAY FROM THE CUTTING
AREA. THERE ARE HAZARDOUS MOVING PARTS.
To power up the cutter, proceed as follows:
1. Make sure the cutter is placed on a flat, level and sturdy surface.
2. Plug one end of the AC power cord into the AC power cord receptacle on the
cutter's rear panel.
3. Plug the other end of the AC power cord into the wall socket.
4. Press the "I" side of the ON/OFF rocker switch on the rear next to the power
inlet to switch the cutter ON.
5. The LCD screen will activate, and if media is loaded, the standard loading
procedure will take place.
General Information
IMPORTANT OPERATIONAL TIP
WARNING
User's Manual
1-15