Beam DriveDOCKExtreme Installation & User Manual page 62

Q5
The Extreme handset is inserted into the DriveDOCK. The battery indicator on
the Extreme handset does not show that the battery is being charged.
A There are a number of reasons which could stop the Extreme battery charging.
When the Extreme handset is inserted into the DriveDOCK, please wait for about
100 seconds for the charging to start.
If the Extreme battery is full, the Extreme handset will stop the DriveDOCK charging
the battery.
If the temperature of the Extreme battery has exceeded 45ºC, the Extreme handset
will stop the DriveDOCK charging the battery. For this reason, if the ambient
temperature is close to 45ºC, no charging will occur due to the safety requirement
for charging Lithium-Ion type battery.
Q6 The Extreme handset is docked in the DriveDOCK and seems to turn o about
20 minutes after the vehicle's ignition is switched o OR the key is removed.
A This is normal for DriveDOCK. If the DriveDOCK needs to stay on while the ignition
is o , please wire the yellow accessory input on the DriveDOCK cable loom to a
constant power source in the vehicle, e.g. 12/24VDC.
Q7 A call is established using the privacy handset but the other end (party B)
cannot hear my voice.
A Check if the Mute LED is illustrating red. If so, the mute function is enabled. Press the Mute
button once to disable the mute.
Check if the Bluetooth® LED is ashing blue at 1.5 second on and 1.5 second o rate.
If so, the DriveDOCK is currently connected to a previously paired Bluetooth® device.
Press the Bluetooth® button on the DriveDOCK until a beep sounds to turn o the
Bluetooth®.
Q8
If my SIM card has a pin code, do I need to manually unlock the SIM card every
time I dock my Extreme handset into the DriveDOCK?
A
The user can save their SIM pin code into the DriveDOCK via the Eagle application.
Once saved, the DriveDOCK will automatically enter the pin code while the Extreme is
inserted into the Dock.
Status LED Error Codes
ALTERNATING (Slow Flashing)
RED IJ
YELLOW
YELLOW IJ
GREEN
RED IJ
YELLOW IJ
GREEN
For additional product support contact BEAM:
Web: wwwbeamcommunications.com
Info: info@beamcommunications.com | Support: support@beamcommunications.com
Tel: +61 3 8588 4500 | Fax: +61 3 9560 9055
62
DPL communication, or PCM Clock problem
Short-circuit on "Alert Loop" output or "Horn alert / Audio system mute"
output
System Error (see Log in Eagle). The Arrow buttons will also ash
ORANGE in this state.