Beam DriveDOCKExtreme Installation & User Manual page 29

Portable satellite telephone

Hide thumbs Also See for DriveDOCKExtreme:

Table of Contents

Step 9 - Bluetooth® Con guration (Optional)

DriveDOCK has an in-built Bluetooth® module for voice connectivity.

NOTE:

In this manual, when there is a reference to the Bluetooth® button or

the Bluetooth® LED it is referring to the button shown below located

on the front of the DriveDOCK Extreme.

To con gure/pair to a Bluetooth® headset (audio) device:

Power up the DriveDOCK Extreme cradle.

Press and hold the Bluetooth® button on the cradle for 5 seconds,

until the cradle sounds a double (2) beep. The Bluetooth® LED will

then ash blue and orange.

Hold the headset (device) button(s) to enter the pairing mode

(please refer to the headset user manual).

Once the devices are successfully paired, the Bluetooth® LED on the

cradle will change to solid blue.

Bluetooth® can be turned ON with a single press, and OFF by

pressing and holding the Bluetooth® button for 2 seconds on the

cradle. The cradle will sound a single (1) beep when turning o . Once

paired, the DriveDOCK Extreme will automatically connect to this

device every time the DriveDOCK Extreme powers up.

You may repeat this process to pair more than one headset. Ensure only

one device is switched on during subsequent pairing con guration.

To clear (delete) all the registered devices from the cradle settings, press

and hold the Bluetooth button (10 seconds) until 3 beeps are heard.

NOTE:

Once a Bluetooth device is discovered, the DriveDOCK will attempt to

pair to that device by trying each of the password "0000", "1234", and

then the optional password set in the Eagle.

Table of Contents