To Set At A Desired Speed; To Deactivate; To Resume Speed; To Vary The Speed Setting - Jeep 2007 Patriot Owner's Manual

128 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
WARNING!
Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always
leave the system OFF when you are not using it.

To Set At A Desired Speed:

When the vehicle has reached the desired speed, press
down on the lever and release. Release the accelerator
and the vehicle will operate at the selected speed.
NOTE: The vehicle should be traveling at a steady
speed and on level ground before pressing the SET lever.

To Deactivate:

A soft tap on the brake pedal, pulling the speed control
lever towards you "CANCEL", or normal brake or clutch
pressure while slowing the vehicle will deactivate speed
control without erasing the set speed memory. Pressing
the ON/OFF button or turning off the ignition switch
erases the set speed memory.

To Resume Speed:

To resume a previously set speed, push the "RESUME
ACCEL" lever up and release. Resume can be used at any
speed above 20 mph (32 km/h).

To Vary The Speed Setting:

When the speed control is ON, speed can be increased by
pushing up and holding "RESUME ACCEL". Release the
lever when the desired speed is reached, and the new
speed will be set.