General Inspection And Cleaning - SeaDoo 2002 GTX 4-TEC Operator's Manual

2
F18H0HY
To remove fuse, lift tab then pull holder
out. Pull fuse out using cover on MPEM
as shown above.
Reassemble removed parts.
General Inspection and
Cleaning
Inspection
Check engine compartment for any dam-
age and for leaks of fuel, coolant or oil.
Ensure all hose clamps are properly se-
cured and no hose is cracked, kinked or
presenting any other damage.
WARNING
If any gasoline leak and/or odor are
present, do not start the engine.
Have the watercraft serviced by an
authorized Sea-Doo dealer.
74
1
Inspect muffler, battery, fuel tank and
oil reservoir fastening devices. Visually
check electrical connections for corro-
sion and tightness.
Inspect hull and jet pump water intake
grate for damage. Replace or have dam-
aged parts repaired.
WARNING
Periodically verify the seat lock pin
and tighten if needed. Make sure
seat securely latches.
Cleaning
The bilge should be cleaned by an au-
thorized Sea-Doo dealer to remove any
fuel/oil/electrolyte deposits and mildew.
Occasionally, wash the body with wa-
ter and soap (only use mild detergent).
Remove any marine organisms from
engine and/or hull. Apply non-abrasive
wax such as silicone wax.
CAUTION: Never clean fiberglass and
plastic parts with strong detergent,
degreasing agent, paint thinner, ace-
tone, etc.
Stains may be removed from seat and
fiberglass with Knight's Spray-Nine
from Korkay System Ltd or the equiv-
alent.
Respect the environment by ensuring
fuel, oil or cleaning solutions do not
drain into the waterways.