Vacuum Bailer Pick-Ups; Fuses - SeaDoo 2002 GTX 4-TEC Operator's Manual

Refer to an authorized Sea-Doo dealer
if an adjustment is necessary.
WARNING
Ensure the handlebar and jet pump
nozzle operate freely from side to
side and are not stressing the steer-
ing cable or brackets. Never turn
handlebar while someone is near-
by rear of watercraft. Keep away
from steering moving parts (noz-
zle, side vanes, linkage etc.).

Vacuum Bailer Pick-Ups

They are located each side of the drive
shaft tunnel.
Two pick-ups use a low pressure area in
the jet pump to siphon the water out of
the bilge when the engine is operating.
Inspect each pick-up screen for ob-
structions, clean as necessary.
F18L11Y
TYPICAL
1. Vacuum bailer pick-ups
70
1

Fuses

If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.
A15E0KZ
1. Fuse
2. Check if melted
3. Ampere rating
Follow procedures below
WARNING
Do not use a higher rated fuse as
this can cause severe damage. If a
fuse has burnt out, source of mal-
function should be determined and
corrected before restarting. See an
authorized Sea-Doo dealer for ser-
vicing.
Fuses can be found on the MPEM in en-
gine compartment and one can be find
in front of fuel tank.
NOTE: To understand the acronyms
used here, refer to ABBREVIATIONS
USED IN THIS MANUAL section at the
end of the guide.
1
2
3
.