Launching/Loading; Storage; Body Rinsing/Repair; Fuel System - SeaDoo 2002 GTX 4-TEC Operator's Manual

A SEA-DOO cover can protect the wa-
tercraft, particularly before driving on
dirt roads, to prevent dirt entry through
the air intake openings.
Observe trailering safety precautions.

Launching/Loading

CAUTION: Before launching the wa-
tercraft, ensure the bilge drain plugs
are fully screwed. After loading the
watercraft, ensure they are removed
to drain bilge.

Storage

WARNING
Because fuel and oil are flamma-
ble, have an authorized Sea-Doo
dealer inspect the fuel system in-
tegrity as specified in the periodic
inspection chart.
It is recommended that the watercraft
be serviced by an authorized Sea-Doo
dealer for storage but the following op-
erations can be performed by you with
a minimum of tools.
CAUTION: Do not run the engine dur-
ing the storage period.

Body Rinsing/Repair

Wash the body with soap and water so-
lution (only use mild detergent). Rinse
thoroughly with fresh water. Remove
marine organisms from the hull.
CAUTION: Never clean fiberglass and
plastic parts with strong detergent,
degreasing agent, paint thinner, ace-
tone, etc.
For gelcoat repairs, refer to an autho-
rized Sea-Doo dealer. Replace dam-
aged labels/decals.

Fuel System

SEA-DOO fuel stabilizer (or equivalent),
can be added in fuel tank to prevent fuel
deterioration and fuel system gum-
ming. Follow stabilizer manufacturer's
instructions for proper use.
76
CAUTION: Fuel stabilizer should be
added prior to engine lubrication to
ensure fuel system components pro-
tection against varnish deposits.
WARNING
Fuel is flammable and explosive
under certain conditions. Always
work in a well ventilated area. Do
not smoke or allow open flames or
sparks in the vicinity. Fuel tank may
be pressurized, slowly turn cap
when opening. Never use an open
flame to check fuel level. When fu-
eling, keep watercraft level. Do not
overfill or top off the fuel tank and
leave watercraft in the sun. As tem-
perature increases, fuel expands
and might overflow. Always wipe
off any fuel spillage from the wa-
tercraft. Always wipe off any fuel
spillage from the watercraft.
Engine Oil and Filter
Replacement
The oil change and filter should be per-
formed by an authorized Sea-Doo dealer.
Exhaust Cooling System
Flushing and Engine
Internal Lubrication
Lubrication
Connect a garden hose to cool the ex-
haust system as explained in Flushing
under POST-OPERATION CARE.
Bring engine to normal operating tem-
perature.
CAUTION: Properly follow the instruc-
tions given in the flushing procedure.
Close the water tap, then stop the en-
gine.
Pull engine cover upward to remove it.