Microscope Base - Nikon ECLIPSE TE2000-E Instructions Manual

I. Parts of the microscope and their names

2. Microscope base

Note: Be sure to cover unused ports with supplied caps to prevent the entry of external light and dust.
Eyepiece-tube clamp screw
Observation port
Install the eyepiece tube.
Front port
Photo-mask dial
Clockwise turn: OUT
Counterclockwise turn: IN
Intermediate magnification dial
1X: No intermediate magnification
1.5X: 1.5X intermediate magnification for all ports
REFOCUS switch
Raises the objective to the
COARSE FOCUS
memorized position.
ESCAPE switch
Lowers the objective to the Escape position.
Fine focus knob
The distance of travel achieved by one rotation of the knob
can be set to Fine, Middle, or Coarse.
The knob is set to Coarse at the factory.
T-RCP remote control pad
Not required when the microscope is controlled using a PC
Objective
Nosepiece
Mount for analyzer
Install the analyzer here
for DIC microscopy.
Adapter clamp screw
Left-side port
Optical path switch-over
section holding screw
This screw is installed for transportation.
Be sure to remove the screw before using the microscope.
8
TE2000-E, right side
REFOCUS
ESCAPE
TE-2000E, left side
T-HUBC HUB controller
The specified AC adapter is required.
Adapter clamp screw
Right-side port
Bottom port
DIA-LAMP ADJ key
Used to adjust the view field brightness.
This key can be used only
when the T-DH dia-illuminator 100W
is installed.
Turn on the green
indicators.
Light path key
Changes the optical path.
Observation 20%
Observation 100%
Front 80%
Observation 20%
Left 100%
Bottom 100%
Stage
Black cover for elevating section
Remove the cover when installing
the epi-fl attachment.
Mount for cassette holder
For the installation of the cassette holder
for epi-fl microscopy
Dia-illumination ON/OFF switch
Brightness adjustment dial
This dial is disabled
when the remote control pad
is used for bright adjustment.
Coarse focus knob
Right 80%