Viewing Information On The Display Panel; Reverting Back To The Factory Default Settings - Sony HT-M77 Operating Instructions Manual

Viewing information on
the display panel
The display panel provides various
information of the receiver status such as
sound field.
AMP
MENU
1
Press the corresponding INPUT
SELECTOR button which you want
to check the information.
2
Press DISPLAY repeatedly.
Each time you press the button, the
display changes cyclically as follows:
Index name of the input* t Input you
selected t Sound field currently
applied t Volume level t Stream
information**
When listening to FM and AM
radio
Preset station name* t Frequency t
Sound field currently applied t
Volume level
* Index name appears only when you have
assigned one to the input or preset station
(page 27, 32). Index name does not appear
when only blank spaces have been entered, or
it is the same as the input name.
** Stream information may not be displayed.
INPUT
Reverting back to the
SELECTOR
buttons
factory default settings
You can clear all memorized settings and
revert the receiver back to the factory
default settings by performing the
following procedure. This procedure can
DISPLAY
also be used to initialize the receiver before
you use it for the first time.
Be sure to use the button on the receiver to
perform this operation.
?/1
1
Press ?/1 to turn off the receiver.
2
Hold down ?/1 for 5 seconds.
The "CLEARING" appears on the
display panel for a while, then changes
to CLEARED *.
Changes or adjustments made to the
settings are now reset to the defaults.
49
GB