Sony HT-M77 Operating Instructions Manual page 36

Connecting a Bluetooth
device
You can connect to a Bluetooth device
from this receiver.
Check the following before playing music:
– The Bluetooth function of the Bluetooth
device is turned on.
– The pairing has been completed
(page 35).
1
Place the Bluetooth device within
1 meter from this receiver.
2
Press BLUETOOTH
You can also use INPUT SELECTOR
on the receiver.
3
Perform connecting on the
Bluetooth device.
For details, refer to the operating
instructions of your Bluetooth device.
4
N
Press to start playback.
5
Adjust the volume.
Adjust the volume of the Bluetooth
device first, if the volume level is still
too low, adjust the volume level on the
receiver.
To disconnect the Bluetooth device
Bluetooth connection can only be
disconnected by the Bluetooth device or if
there is a signal loss.
To delete a paired Bluetooth device
from the device list
Initialize the receiver (page 49).
Notes
• Depending on the type of Bluetooth device, you
can adjust the volume using the controls of the
Bluetooth device.
• If you cannot connect with a paired Bluetooth
device, perform the pairing operation between
the receiver and the Bluetooth device again.
• If the input has been set to "BLUETOOTH"
when you turn on the receiver, the receiver
automatically connects to the last connected
Bluetooth device.
36
GB
To operate the Bluetooth
device using the remote
control
NX*
Once the receiver and the Bluetooth device
are connected, you can control playback by
pressing NX*, m/M and ./>.
* If no Bluetooth device is connected and you
press NX, the receiver automatically
connects to the last connected Bluetooth device
and play back the music.
Note
These operations may not be available for certain
Bluetooth devices. In addition, the actual
operations may differ depending on the
connected Bluetooth device.
Setting the Bluetooth
Standby mode
You can set the Bluetooth Standby mode so
that the receiver can be controlled by the
Bluetooth device even when the receiver is
in standby mode.
1
Press BLUETOOTH.
You can also use INPUT SELECTOR
on the receiver.
2
Press AMP MENU.
3
Press V/v repeatedly to select
"BT", then press
4
Press V/v repeatedly to select
"BT STANDBY", then press
b.
5
Press V/v repeatedly to select
"STBY ON", then press
The receiver turns on automatically
when you establish the Bluetooth
connection from the Bluetooth device.
m/M
./>
or b
.
or
.