Trouble [4] Failure to Communicate
Trouble [5] Zone Fault
Trouble [6] Zone Tamper
Trouble [7] Wireless Device Low Battery
1st press
– Wireless Zones
2nd press
– Wireless Keys
Trouble [8] Loss of Clock/Date
Panel fails to communicate one or more
events to central station
Press [5] to determine specific zones with a Fault trouble
Hard-wired zone fault condition present.
A short circuit is present on one or more
zones with double end-of-line resistors
enabled
One or more wireless devices have not
checked in within the programmed time
Press [6] to determine specific zones with a Tamper trouble
An open circuit is present on one or
more zones with double end-of-line
resistors enabled
A tamper condition is present on one or
more wireless devices
Press [7] to scroll through specific devices with a Low Battery Trouble
One or more wireless devices has a low
battery
NOTE: The event will not be logged to
the event buffer until the wireless device
low battery delay time expires
Program Section [377] Opt 9
The main panel internal clock is not set
WWW.DIYALARMFORUM.COM
Section 9: Testing & Troubleshooting
Connect a headset to TIP and RING of the control panel. Monitor for
the following conditions:
•
Continuous dial tone
• Reverse TIP and RING
•
Recorded operator message comes on
• Verify correct phone number is programmed
• Dial the number programmed using a regular telephone to
determine if a [9] must be dialed or if 800 service is blocked.
•
Panel does not respond to handshakes.
• Verify the format programmed is supported by the central
station.
•
Panel transmits data multiple times without receiving a
handshake
• Verify that the account number and reporting codes are
correctly programmed.
NOTE:
Contact ID and Pulse formats
•
Program a HEX [A] to transmit a digit [0]
SIA format
•
Program a digit [0] to transmit a digit [0]
•
Remove the wire leads from I/O and COM terminals and
measure the resistance of the wire leads.
Connect a 5.6K resistor (Green, Blue, Red) across the I/O and
COM terminals. Verify the trouble condition clears.
•
Perform a Module Placement Test – Program Section [904] and
verify the wireless device is in a good location.
•
If bad test results occur, test the wireless device in another
location
•
If the wireless device now tests good, the original mounting
location is bad
•
If the wireless device continues to give bad test results
replace the wireless device.
•
Remove the wire leads from I/O and COM terminals and
measure the resistance of the wire leads.
•
Connect a 5.6K resistor (Green, Blue, Red) across the I/O and
COM terminals.
• Verify the trouble condition clears.
•
Ensure device cover is secure
•
Ensure device is correctly mounted for wall tamper operation
•
Violate, then restore the tamper:
• If tamper condition persists then replace wireless device
Replace Battery
•
Verify zone operation
•
Verify that tamper and low battery condition is cleared and
reported
NOTE: Replacing batteries will cause a tamper. Replacing cover will
restore the tamper causing the associated reporting codes to be sent
to the Central Station.
To program the time and date:
•
Enter [✱][6][Master Code] then Press [1]
•
Enter the time and date (in military) using the following format:
HH:MM MM/DD/YY
Example.
For 6:00 pm, Nov. 30, 2007
Enter: [18] [00] [11] [30] [07]
49