Jacto HP726 Owner's/Operator's Manual page 11

Starting the Engine (Cont.)
Figure 12
7. Set the choke lever to the closed
position. See figure 12.
Figure 13
8. Hold the HP726 firmly with one
hand. Slowly pull the recoil starter
handle until resistance is felt, then
pull quickly to start the engine.
See figure 13.
CAUTION!
Do not pull the recoil starter to the
end of the rope travel. Pulling the
recoil starter to the end of the rope
travel can damage the starter.
10
Choke Closed
Figure 14
9. When the engine starts, slowly
move the choke lever to the
"OPEN" position. If the engine
stops after the initial start, close the
choke and restart. See figure 14.
IMPORTANT!
If the engine fails to start after
several attempts with the choke in
the closed position, the engine may
be flooded with fuel. If flooding is
suspected, move the choke lever to
the open position and repeatedly pull
the recoil starter to remove excess
fuel and start the engine.
If the engine still fails to start, refer to
the troubleshooting section of this
manual.
Choke Open