Cleaning & Caution - Master Bilt CCR-23SR Installation And Operation Manual

CLEANING
1. CLEANING THE INTERIOR AND EXTERIOR
- The interior and exterior of the unit can be cleaned using warm water with soap.
- Do not use an abrasive cleaner because it will scratch the stainless steel surface.
2. CLEANING THE CONDENSER FINS
- To maintain proper refrigeration performance, the Condensing coil must be free of
dust, dirt and grease.
This will require periodic cleaning. Condenser fins should be cleaned at least every
three months (90 days) or as needed.
3. CLEAN THE GASKET
- The door gasket should be cleaned frequently to maintain proper sealing.
4. CHECK AFTER CLEANING
- Check the unit again for safety.
- Check that the unit is operating properly.
CAUTION
1. POWER CORD
- Be sure that the power cord is connected to the proper voltage.
- A protected circuit of the correct voltage and amperage must be run for connection of
the line cord.
- Turn 'off' the power switch before disconnecting the power cord, whenever
performing maintenance functions or cleaning the refrigerated
cabinet.
- Dual voltage freezer (CCR-72TF) requires receptacle as the right
sides.
- Compressor warranties are void if compressor burns out due to low
voltage.
2. RE-STARTING
- If disconnected, wait 5 minutes before re-starting.
4
WH
BK RD
E