How To Interrupt A Programme; How To Open The Door During The Cycle Of A Programme; End Of Programme - John Lewis JLBIWM1401 Instruction Manual

Built-in 1400 spin
Table of Contents

Advertisement

11. How to interrupt a
programme
Depress the "Start/Pause" button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.
12. How to open the door
during the cycle of a
programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• the machine is not in the heating phase beyond 55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
washer dryer, the door can be opened.
Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the machine
off by pressing the "On/Off" button.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the door and press the "On/Off"
button again, the machine will resume the programme
from the point where it had been interrupted.

13. End of programme

At the end of the programme, the machine stops
automatically . The "End" light illuminates. The
"Start/Pause" button light goes off and the display
shows a flashing zero.
If the "Rinse hold" or "Quiet" option has been
selected, the "Rinse hold" pilot phase light, the
"Quiet" or "Rinse hold" option light remain lit (the
door will be locked) to indicate that the water must be
emptied out before opening the door. The display
shows a flashing zero.
To drain the water or to spin see the steps of the
paragraphs "Quiet" or "Rinse hold" on page 16.
Release of the lock is also indicated by the illumination
of the "End" light.
Turn the programme selector dial to Reset "Off" and
then press the "On/Off" button to switch the machine
off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the machine.
22 22

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jlbiwm 1401

Table of Contents