Table of Contents
Advertisement
Start the programme
Press the "Start/Pause" button. The relevant green
light will stop flashing.
If you have chosen a delayed start, the washing machine
will begin the countdown.
The display will show the duration of the programme
or the selected delay.
How to change an option or a
programme during its cycle
It is possible to change some options before the
programme carries them out. Before you make any
change, you must pause the washing machine by
pressing the "Start/Pause" button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to "Off" and then
to the new programme position.
Start the new programme by pressing the
"Start/Pause" button. The washing water in the tub
will not empty out
How to interrupt a
programme
Press the "Start/Pause" button to interrupt a
programme which is running, the corresponding light
starts to flash. Press the button again to restart the
programme.
How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• The washing machine is not in the heating phase
beyond 55°C;
• The level of the water is not high;
If these requirements are met, when you pause the
washing machine, the "Door lock" light goes off and
the door can be opened.
Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the machine
off by turning the selector dial to "Off".
After a few minutes, you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the door to restart the programme
turn the dial to the previous programme repeating the
options previously selected and press Start/Pause
button.
End of programme
At the end of the programme, the washing machine
stops automatically, the "Start/Pause" button light and
the "Door lock" light go off, the display shows a
0
flashing zero
. It is possible to open the door.
«
»
If you had selected the "Rinse hold" or "Quiet"
option, the "Door lock" light remains lit to indicate that
the door is locked and the water must be drained.
To drain or to spin see paragraph "Quiet" on page
13.
Turn the programme selector dial to Reset "Off" to
switch the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
19
Advertisement
Table of Contents
