Table of Contents
Advertisement
machine on. The Start/Pause light starts to flash and
the display shows the duration of the selected
programme.
To switch the appliance off turn it to "Off".
Select the desired
programme/temperature
Turn the selector dial to the desired position (Cottons
90° in this case). The display will show the duration of
the selected programme, calculated on the basis of the
maximum load for each type of fabric. The
Start/Pause button light will start flashing.
If your laundry needs a soak time, turn the programme
selector dial to "Soak" and then, before starting a
washing cycle, drain the water as described in the
"Soak" paragraph.
Select the spin speed or
"None" option
Press this button repeatedly in order to select the
desired spin speed or the "None" option.
Select the desired options
If your laundry has heavy stains and it is necessary to
prolong the washing time, select the "Stain" option.
lightly soiled, select the "Quick" option.
The relevant light will light
up.
The special detergent for
stains (Stain remover) is
loaded from the compart-
ment marked
.
If your laundry is very
dirty, it may be advisable
to select the "Prewash"
option.
If your laundry is only
If you wish the laundry to undergo an extra rinse,
select the "Extra Rinse" option.
If you do not want your laundry to be creased, select
the "Rinse hold" option to leave the fabrics in the
water of the last rinse. The relevant light illuminates.
Select the "Delay start"
Before you start the programme, if you wish the
start to be delayed, press the "Delay Start" button
repeatedly, or keep it pressed, to select the desired delay.
Start the programme
Press the "Start/Pause" button. The relevant green
light will stop flashing. If you have chosen a delayed
start, the washing machine will begin the countdown.
The display will show the duration of the programme
or the selected delay.
How to change an option or a
programme during its cycle
It is possible to change some options before the
programme carries it out. Before you make any change,
you must pause the washing machine by pressing the
"Start/Pause" button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to
«Off» and then to the new programme position.
Start the new programme by depressing the
"Start/Pause" button. The washing water in the tub
will not be emptied out.
How to interrupt a programme
Press the "Start/Pause" button to interrupt a
programme which is running, the corresponding light
starts to flash. Press it again to restart the programme.
How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• The washing machine is not in the heating phase
beyond 55°C;
10
The selected delay time
value (up to 20 hours)
will appear on the display
for a few seconds, then
the duration of the
programme will appear
again.
Hide quick links:
Advertisement
Table of Contents
