Programme Selector Dial - John Lewis JLBIWM1401 Instruction Manual

The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the Start/Pause button, the
countdown is updated every hour, and, for the last
two hours, every 30 minutes.
• An incorrect option selection has been made:
this is indicated by the message Err when a function
incompatible with the current programme is selected.
• An alarm code indicates a fault in the machine
operation (see page 29, "Something Not Working").
11 Programme phase indicator
lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried out
will remain lit.
When the washing programme has finished, the "End"
light comes on and a flashing zero appears on the
display. The light of the "Start/Pause" is off.
The "End" pilot light flashes in the event of operating
problems. And the relative alarm code appears on the
display.
E E 1 1 0 0
= the machine does not fill
E E 2 2 0 0
= the machine does not empty
E E 4 4 0 0
= the door has not been closed
To eliminate the problem, see paragraph "Something
not working" (pages 29-30).
Important!
If you turn the programme selector dial to another
programme when the machine is working, all the lights
of the programme progress display will flash for about 2
seconds but the machine will not perform the new
selected programme.

12 Programme selector dial

The programme selector dial is divided into the
following sections:
• Cottons,
• Synthetics,
• Delicates
• Wool / Hand washing
• Special programmes from "Soak 30°" to
"30 Minute wash"
• Reset programme "Off"
The selector dial can be turned either clockwise or
anticlockwise to select the required wash programme .
"Economy" position corresponds to an ENERGY
SAVING programme and "Cold" to a cold wash.
Before setting the dial to any position ensure that the
machine is turned to the "Off" position.
Important!
At the end of the programme the selector dial
must be turned to position "Off".
18