Table of Contents
Advertisement
IPECS
Release 5
Hardware Description & Installation
4.5.11 BRIM2 Installation
The BRIM2 may be installed anywhere except for slot 10 of the cabinet, or may be installed
anywhere in the Desk Mount Holder. The BRIM2 provides a gateway between ISDN Basic Rate
Interface (BRI) lines and other iPECS appliances.
The BRIM2 can support two (2) BRI lines as a "T" interface.
LEDs
In addition to the Power and LAN LEDs, there are four LEDs, two for each BRI circuit, which
provide the status information as described in Table 4.5.11-1 .
Wiring Connectors
Before wiring any of the Modules, first connect the "
known ground, refer to section 4.5.1.4.
On the front of the BRIM2 is the RJ 45 type "LAN" connector. This connector should be wired to the
appropriate LAN points as discussed in section 4.5.1.6 and 4.5.1.7.
Wire "LAN" to a 10/100 Base-T switch, a POE8 can be used to connect to the LAN.
Tag or number wiring for maintenance
On the rear are two (2) RJ-45 connectors terminated to the BRI Line interface circuits. These
connectors should be wired to the telephone company termination point ('T' Mode). The connector
pin assignments for the RJ-45 type jacks on the BRIM2 are shown in Figure 4.5.11-1.
Wire each RJ-45 to a BRI line at the ISDN termination point/MDF.
Tag or number wiring for maintenance.
AC/DC Adapter
If a PSU is not employed, assure the AC/DC Adapter is plugged into a live AC outlet and the
Module Power jack.
Table 4.5.11-1 BRIM2 Status LED Function
LED DESIGNATION
ACT
ERR
ON
OFF
In Use
Idle
Line Error
Normal
" screw on the back of the Module to a
85
Issue 5.0
Hide quick links:
Advertisement
Table of Contents
